Punch needle chair pads and stools
Make a round 300 mm chair pad with a punched front, fabric back and optional fabric ties.
Template and size
300 × 300 mm finished design. Add mounting margins and the sewing allowance given in the steps.
Print the circle study pattern at this size, then follow the making and finishing steps below.
Supplies
- Matched punch materials
- Backing fabric and optional thin pad insert
- Fabric tape for ties and sewing thread
Keep a front-view paper copy and your fibre labels beside the frame. Use spare cloth to check the needle, fibre and foundation before beginning.
Make the project
Measure the seat
Use a paper circle to check the actual chair or stool. Resize the 300 mm template so it stays within the seat and clear of the back supports.
Punch the surface
Work a consistent low surface and keep its circle round. Leave the foundation beyond the punched area for a sewing allowance.
Prepare the back
Cut the backing to the same outline with 10 mm seam allowance. If using ties, mark positions that reach the intended chair supports without crossing the sitting surface.
Sew and turn
Place the two pieces right sides together, catching tie ends in reinforced seam sections. Leave an opening, turn, add an optional insert and close it.
Finish and care
Fit the pad to the actual seat and check that it stays in place. Tie to supports without placing loose cords on the floor.
Use the full yarn, backing and insert combination when choosing cleaning.